Seeding for Target Plant Stands, not lbs/ac

Seed can be an expensive input, but a poor crop stand can be lost profit.  To maximize your seed, still get the stand needed to optimize yield, start calculating the real seeding rate needed for the plant stand desired and not gauging seeding rate by lbs/ac or bu/ac.

The following are the standard recommendations for FINAL plant stand, not what you are putting in the ground. Germination, TKW and mortality are very important to use in the equation to determine actual seeds/ac to plant.  For example, if you assume your germination is 96% and its only 85% and conditions turn cold and wet (increasing mortality), you may have a lot thinner stand than you anticipated (which could mean a harder time controlling weeds).

                    Grain Crops                               Oilseed Crops                   Pulse Crops        
Barley Wheat Oat Corn Canola Sunflower Flax Peas Soybean Dry Bean*
Plants/ft2 22-25 23-28 18-23 7-14 37-56 7-9
 Plants/ac (1000s) 26-30 18-22 180-210 85-100
Mortality Rates (%) 10-15 10-15 10-15 10-15 20-60 10 40-50 5-15 5-10 5-10

*Navy Bean = pinto beans on lower end and navy bean require higher plant stands

Source:  Manitoba Agriculture, Canola Council of Canada, Flax Council of Canada, Ontario Ministry of Agriculture, Food and Rural Affairs

 Seeding Rate (lbs/ac) = target plant stand/ft2 x TKW (g) / % expected seed survival x 10                       

 e.g. FLAX Seeding Rate= 45 plants/ft2 x  5g (TKW) / ((88% germination x (1- 40% mortality)) X 10 = 43 lbs/ac

Other information

Wheat – http://www.gov.mb.ca/agriculture/crops/production/print,aiming-for-higher-wheat-yields.html

Using 1000 Kernel Weight for Calculating Seeding Rates – http://www1.agric.gov.ab.ca/%24department/deptdocs.nsf/all/agdex81

Canola – http://www.canolacouncil.org/canola-encyclopedia/crop-establishment/seeding-rate/

Optimizing Plant Establishment – http://www.gov.mb.ca/agriculture/crops/production/pubs/optimizing-stand-establishment-in-less-than-optimal-conditions.pdf

 

Leave a Reply

You must be logged in to post a comment.